IMO, a 7" wheel is ideal for 255/85s. I've had them on 6" and 6.5" wheels and they wore evenly there too. 255 is the width in millimeters. 85 is...
Alright... I have a DRW Dana 70 in my '97 E350 that I use for work. Its only 32-spline. I just found out the disc setup they use from 99+ won't...
255/85R16 = 33x10.5" BFG and Toyo make them with 3400-3750# capacity.
DRWs have their purpose... - a payload that requires the higher GAWR afforded by the extra tires (and sometimes heavier-duty axle) - the load has...
'95 F350 with PSD here :pimp: I figure the clutch won't last forever with the mods going in. Too bad the 6.2/6.5 isn't in the offering.... I...
I spent 4 years at a wrecking yard where rear-ends and ratios were mixed and matched to the customers needs. Backlash set to factory tolerances...
4.10 needs a different offset carrier on the Dana 80. You may want to consider a posi and/or locker at that point because its no more effort to...
Whats this? The Supercab guys whining about turning radius? :rolleyes::stir:
The wheels/adapters came from here: http://www.chromewheel.com/
It doesn't rub, but its a 99% pavement rig. Might rub if it was offroaded. It is tricky to load a camper! The tires hang out of the rear wheel...
Here's my bro's '06 with 22.5's and only a levelling kit [IMG]
Pleasure use is cheaper for a given GVWR. Also, only insure to the GVW you plan to use.... this amount may or may not have to include what you are...
I do my rounds on Pirate... I don't mind the 'atmosphere' there :D My thinking was there are more 94+ Dodge owners on a towing-specific forum...
Anyone tried GM Dana 60 spindles, hubs, & rotor on their Dodge D60 disconnect axle? I would assume drilling a few holes is necessary...
I'm running 235/85R16s. IMO revs too high for highway travel. Too bad there isn't anything in a 35" AT or MT tire that fits the 7" wide rim. The...
One thing I like better on the 94.5-95 is the ratios on the ZF.
See if you can hunt down a Cummins 4BT (3.9L) from a GM bread van. Excellent torque and economy. waytogo You could get into a 5.9L Cummins from...
What transmission do you have? TH700? You have a non-electronic engine... and most likely a non-electronic trans - yet the engine light comes...
Some DIY action... :stir: http://www.swamp-donkey.biz/content/faq/EBPV_Brake.htm
JB8 brakes use 13x3.5" drums, and 1.5" thick rotors w/Bendix calipers. I haven't seen any 1-tons since the mid 70's that used the JB7 (normally...
Separate names with a comma.
